Research and Application of Materials Science

Basic Properties of Pyrolysis carbon black of Waste Tyres and Application of Pyrolysis carbon black in Transition Layer Rubber of All Steel Radial Tire

LIUQi, LiHui, LiJian

Abstract


The main chemical composition of pyrolysis carbon black of waste tires is C, O, Cu, Zn and so on. The content of ash and fine powder in pyrolysis carbon black is high, and the 300% elongation stress is high. The difference between pyrolysis carbon black and furnace black N326, which is commonly used in rubber, is obvious compared with chemical property. The pyrolysis carbon black was used to replace furnace black N326 in the transition layer of all steel load Radial tire rubber through experimental study. It was found that the compression heat generation and dynamic loss (TanĪ“) of the blend rubber before and after aging were obviously reduced, the elongation at break and resilience increased, while the tensile stress and tear strength decreased by 100% and 300% , but the hardness and tensile strength changed little before and after aging. According to the latest raw material price calculation, 15 used tire pyrolysis carbon black instead of furnace carbon black N326 used in all steel Radial tire transition layer rubber application, excluding labor costs, electricity and equipment depreciation, a ton of blended rubber saves about $22.86 in production costs.

Keywords


waste tyre; pyrolysis carbon black; all steel radial truck tire; the transition layer formula; mixing rubber

Full Text:

PDF

References


zhao wen-jin, liu jia, new progress in pyrolysis recycling of waste tires (2009), rubber technology and equipment 36 (7) : 9-15

cheng yuan, a new bright spot of waste tire recycling -- negative pressure cracking (2008), proceedings of forum on recycling of waste tire resources in China, 2008.11

Shen bo-xiong, Lu feng, Liu ting, modification of carbon black cracking of waste tires (2009), Chemical Journal 60(9): 2327-2331

Du ai-hua, Su chang-yan, Chen Hong, Leng hai-yan, Waste Tire Rift Carbon Black Basic Properties and Its Application in Butyrene Rubber (2009), Synthetic Rubber Industry 31(6): 446-449

Xiao guo-liang, Peng xiao-qin, Gai guo-sheng, ultra-fine crushing and surface modification of carbon black cracking of waste tires and application in NR (2004). Rubber Industry 51(2): 78-82

Peng xiao-qin, Xiao guo-liang, deep processing and application of carbon black cracking of waste tires (2004), Polymer Materials Science and Engineering 20(4): 142-145

guo ying-chen, qiao zhan-ping, waste rubber preparation of fuel oil and carbon black (2001), environmental pollution and prevention 28 (2) : 82-83

liu bao-qing, jiang jia-ling, liu xiao-long, vertical cracking tower for recycling carbon black and fuel oil from waste tires (2004), synthetic rubber industry 27 (1) : 17-20




DOI: https://doi.org/10.33142/msra.v2i1.1977

Refbacks

  • There are currently no refbacks.


Copyright (c) 2020 Qi LIU, Hui Li, Jian Li

Creative Commons License
This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.